C0/C1/C1+/C2 Tinkering Kit

$17.95

Quantity

You're probably itching to put together some fun embedded computer projects with the ODROID-C1, ODROID-XU4 with Shifter Shield, or other SBC with Raspberry Pi compatible 40-pin GPIO header. You need an add-on T-breakout prototype board to provide easy access to all those GPIO, I2C and ADC pins from the 40-pin header onto a solderless breadboard. This set will allow super-easy prototype development.

KEY FEATURES

Assembled T-breakout PCB - 40pin GPIO breakout board
Breadboard contains 630 tie points with dual power lanes
40pin ribbon cable - IDC flat cable 100mm
40pin male-to-male Dupont jumper wires 170mm
(7x) green LED 3mm
(7x) yellow LED 3mm
(7x) red LED 3mm
(2x) photocell (CdS light sensor)
(6x) tactile switches
(50x) 330 ohm 1/6W resistors
(50x) 10 Kohm 1/6W resistors

NOTES

Compatible with the ODROID-XU4 / XU3 / XU3-Lite when using the XU4 Shifter Shield
Pin numbers marked on the T-Header are specifically for the ODROID models. While this may be used with any 40-pin header system, pin numbers may different on other systems.

LINKS

DIY Light Level Meter Video - https://www.youtube.com/watch?feature=player_embedded&v=zocRA1oNY60

Warranty is valid for two weeks, starting upon date of receipt.

Filters

Accessories

Architecture

Bluetooth

Brand

Cases

cases

Charger

Cooling

Plug

Power

RAM

Recommended Power Supply

Smart

WiFi

PINE64

C0/C1/C1+/C2 Tinkering Kit

You recently viewed

Navigate

Community

Support

Follow us

VIP