ODROID-VU5A - 5inch HDMI display with Multi-touch and Audio
In Stock
Disclaimer for Price Display Issues:
We strive to ensure that all prices displayed on our website are accurate. However, in rare cases, you may encounter an incorrect price for a product variant due to technical issues. If you notice a discrepancy in the price displayed when selecting a variant, please try the following steps:
- Clear your browser cache and reload the page.
- Use a different browser.
- Add the variant to the cart.
The correct price will always be displayed in your cart before you complete your purchase. We apologize for any inconvenience this may cause and appreciate your understanding.
What's new and different from the VU5?
- AUDIO JACK: The VU5A (Audio) is meant to be used with sound! Plug in your own speakers or earbuds/headphones into the audio jack (3.5mm)
- AUDIO PORT: plug in the ODROID Speakers (affordable and powered directly from the board) into the audio port
- Additional microUSB PORT when you need more power!
KEY FEATURES
- 5-inch TFT-LCD
- Screen Resolution: 800 x 480 pixels hardware resolution, configurable by software up to 1920x1080
- 5 finger capacitive touch input (USB ID 16B4:0705)
- 3.5mm audio jack and differential L/R speaker port to support HDMI audio output
- OSD menu supports with buttons for power management, brightness/contrast/volume adjustment, etc.
- Power consumption : 500mA/5Volt
- Power on/off tact switch
- Screen Dimensions : 121 x 93.31 x 15 mm including buttons and connectors
- Viewable screen size : 108 x 64 mm (active area)
INCLUDES
- Fully assembled 5inch display
- 6 x 3.5mm screws
- 3 x Hex nuts
- Micro USB link board
- HDMI link board
- Micro-to-TypeA USB Cable (approx. 35cm)
- Micro-to-Micro USB Cable (approx. 35cm)
- TypeA-to-TypeA HDMI cable (approx. 35cm)
Known issues:
1. The display shows noise on the screen in the boot process and power-down process because there is no off-sync filter circuit.
2. On the C1+, there will be after-image or noise when the system turns off if you use the OTG port.
To fix this issue, you must remove(de-solder) the R94 from the C1+ PCB.
If you have the C1+ PCB Rev 0.4 2015/09/30, just remove a JUMPER on J8.
3. There is no backlight control except for the slide switch. So software can't adjust the brightness neither turn on-off the backlight.
LINKS
- VU5A Wiki Page - https://wiki.odroid.com/accessory/display/vu_series/vu5a/vu5a
Warranty is valid for two weeks, starting upon date of receipt.