Cases

Looking for a tablet enclosure solution for your Pine A64 single board computer? Look no further than the Playbox Enclosure for PINE A64/A64+, PINE...

KEY FEATURES Compatible with Raspberry Pi 3 Model B+, Raspberry Pi 2 Model B and Raspberry Pi Model B+, and the ODROID-C1+ and ODROID-C2 models al...

Space for Net card and 2 x 3.5” SATA drives. Package contents: A. Cooling fan panel B. Side panel C. Top panel D. Side lock piece E. Rear panel F....

KEY FEATURES Compatible with Raspberry Pi 2/3 Model B and Raspberry Pi Model B+, and the ODROID-C1+ fits (see NOTES below). Material - ABS Color -...

The PiJuice tall case has enough room for you to stack an extra HAT on top of the PiJuice HAT if you desire or fit in a multitude of additional ele...

Space for Net Card and space for 4 x 2.5” SATA drives (max. 15mm thick). The hole for the second Ethernet port of H4+ and H4 Ultra is user-configur...

Space for Net card, no space for SATA storage. Package contents: A. Top panel B. Bottom panel C. Front panel D. Back panel E. Left/Right panel F. ...

KEY FEATURES M3 Threading Outside Measurements: Nylon: ~5.5mm hex Brass: ~4.5mm hex Aluminum: ~4.5mm hex Conductivity: Nylon: Non-conductive B...

Space for a Net Card. No space for SATA storage.A thin 92x92x15mm cooling fan can be installed internally as an option.The hole for the second Ethe...

Made for the ROCK64 and PINE H64-B and laser cut for high dimensional accuracy. Case is powder-coated and includes a fan. It's a fact that single-b...

This is the official Raspberry Pi case Black and Grey Version, designed by the Raspberry Pi Foundation to be the ideal choice for the Raspberry P...

Short Crust Plus is the new version of the Short Crust Case designed specifically for the Raspberry Pi Model B+, the Raspberry Pi 2 Model B and the...

This is the official Raspberry Pi case, designed by the Raspberry Pi Foundation to be the ideal choice for the Raspberry Pi 3.   KEY FEATURES Opti...

KEY FEATURES Fits the ODROID-VU7 touchscreen ABS or PLA Plastic 3D printed on high-end enthusiast 3D printers at a resolution of 0.25mm layer...

The Raspberry Pi Case for Raspberry Pi 5 is a clip-together four-part enclosure with an active cooling fan. It keeps your Raspberry Pi 5 at a...

This case features a sliding lid allowing for easy access to the PiJuice HAT and battery. Small openings on the side will give you access to the...

The Pi PoE Switch HAT case is the perfect enclosure for the Power over Ethernet Raspberry Pi HAT and a Raspberry Pi. It is perfect for removing the...

KEY FEATURES 3D-printed case in 0.25mm or better resolution out of ABS plastic Allows installation of 3.2" Touchscreen Provides access to the 3 bu...

KEY FEATURES Clear Acrylic Panels Toolless design Allows installation of C1 Touchscreen NOTES Assembly required - no tools needed The top pa...

KEY FEATURES Compatible with Raspberry Pi 2/3 Model B and Raspberry Pi Model B+, and the ODROID-C1+ fits (see NOTES below). Material - ABS Colo...

KEY FEATURES M3 Threading through entire standoff Outside Measurements: Nylon: ~5.5mm hex Brass: ~4.5mm hex Aluminum: ~4.5mm hex Conductivity: ...